1. Handling and transportation of high and low temperature test chambers
1. When carrying, lift the foot, do not grasp the force on the door handle, and can not drag on the ground;
2. The maximum tilt angle of the cabinet should not exceed 15 degrees, and it should not be inverted or horizontally placed. Otherwise, the compressor will be damaged or the refrigeration oil in the compressor will flow into the refrigeration pipeline, which will affect the refrigeration and easily cause the compressor to be unspring.
3. During the transportation process, it is necessary to prevent bumps and severe vibrations, and to prevent rain and water from immersing.
Second, the placement method
1. The high and low temperature test chamber should be placed away from the heat source and not exposed to direct sunlight. Because it needs to exchange heat with the outside world during work, it can dissipate heat to the outside through the condenser. The higher the ambient temperature, the slower the heat dissipation and the higher the consumption. The power is low and the cooling effect is poor.
2. The compressor should be placed in a place with low humidity. Because the high and low temperature test chamber casing, condenser and compressor are all metal materials, if the humidity of the air is too high, these parts will rust and shorten the use of high and low temperature test chambers. life. At the same time, the humid and overheated environment will cause condensation on the surface of the test chamber and affect the performance of the machine.
3. Should be placed in a well-ventilated place, if the high and low temperature test chamber is full of debris, or too close to the wall, it is not conducive to heat dissipation will affect the cooling effect.
4. Should be placed on a flat, solid floor and keep the compressor level. This is not only for safety reasons, but also allows the compressor to work smoothly, reducing vibration and noise.
5. Should not be placed in a place where the temperature is too low. Because the temperature is too low, the compressor is difficult to start.
6. Do not place in an environment that is flammable, explosive, or corrosive.
This item is 100% polyester and the density is 119*89. The specification is 63D*63D. It's a featured product in our company and it enjoys great popularity among our clients.
Outdoor Fabric,Pvc Mesh Outdoor Fabric,Outdoor Polyester Fabric,Outdoor Fabric For Garment
WEIHUA TEXTILE , https://www.weihuatex.com